Siemens RDG160KN Manuel de service télécharger pdf (Page 6)

1.4 Target audience, prerequisites

This document assumes that users of the RDG KNX thermostats are familiar with

the ETS and/or Synco ACS tools and able to use them.

It also presupposes that these users are aware of the specific conditions associ-

ated with KNX.

In most countries, specific KNX know-how is conveyed through training centers

certified by the KNX Association (see

www.knx.org/).

For reference documentation, see section 1.2.

1.5 Glossary

The inputs, outputs and parameters of an application can be influenced in various

ways. These are identified by the following symbols in this document:

Parameters identified by this symbol are set using ETS.

Parameters identified by this symbol are set using the ACS tool.

Setting RDG KNX parameters is only supported by the following tool

versions:

– ETS3f or higher

– ACS version 5.11 or higher

Inputs and outputs identified by this symbol communicate with other KNX devices.

They are called communication objects (CO).

The communication objects of the RDG KNX thermostats work partly in S-mode,

partly in LTE mode, and partly in both. These objects are described accordingly.

A list of the parameters is shown in section 3.12.

ETS

ACS

STOP

Note!

KNX

6 / 102

Siemens RDG100KN, RDG160KN Basic documentation CE1P3191en

Building Technologies About this document 2014-05-23

1 2 3 4 5 6 7 8 9 10 11 ... 101 102

Pas de commentaire

Siemens RDG160KN Manuel de service Page 6