Siemens TC63 Manuel d'utilisateur télécharger pdf (Page 453)

TC63 AT Command Set

19.7 AT^SSPI

TC63_ATC_V00.490 Page 453 of 501 5/24/05

Confidential / Draft - Do not copy

19.7.2 Transmitting Data over AT Interface

This section provides information on the protocol used for data transmission to or from I²C devices and explains

the data mode. It is assumed that you are familiar with the I²C specification.

Throughout this section the following document conventions are used to mark the direction of send and receive:

Transfer Message: AT → I²C device driver

Response Message: AT ← I²C device driver

Channel Open / Close:

To change from command mode to data mode use the AT^SSPI write command. To close down the channel

and return to command mode send the ASCII code # (0x23).

ASCII Protocol for I²C communication over AT interface:

The protocol allows using a Terminal program for the communication between the module and the I²C slave

device. To visualize transferred characters and response data it is recommended to run the Terminal program

in chat mode or to switch on local echo.

For transfer and response, special characters are defined, such as Start and Stop to mark a single message and

Close to disconnect the data channel. All valid special characters are listed below:

Table 19.3: Special characters for ASCII coding

Direction

AT - Driver

Function in protocol Special

character

Hex value Description

→ Start Transfer Message < 0x3C Special character sent to the I²C driver to

start sending.

→ Stop Transfer Message > 0x3E Special character sent to the I²C driver to

stop sending.

→ Channel Close # 0x23 For signalling.

Channel Close can be sent any time inside

or outside a transmit or receive message.

Causes the transfer to be aborted and

takes the ME back to AT command mode.

← Start Response Message { 0x7B Special character sent to the I²C driver to

mark the beginning of a Response Mes-

sage.

← Stop Response Message } 0x7D Special character sent to the I²C driver to

mark the end of a Response Message.

← Protocol error ! 0x21 For signalling.

Reports to the AT interface that the Trans-

fer Frame does not comply with the proto-

col definition (syntax error).

← Transmission OK

(in I²C protocol referred to

as ACK)

+ 0x2B Notifies the AT interface that data were

successfully transmitted or the I²C Slave

Address was recognized.

← Transmission error

(in I²C protocol referred to

as NAK)

- 0x2D Notifies the AT interface that data transmis-

sion failed or the I²C Slave Address was

not recognized. On the I²C bus, the faulty

data byte (16 bit byte counter) is identified

as well.

1 2 ... 448 449 450 451 452 453 454 455 456 457 458 ... 500 501

Commentaires sur ces manuels

Pas de commentaire

Siemens TC63 Manuel d'utilisateur Page 453

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Siemens TC63