Siemens DTU3005-B Manuel de l'opérateur télécharger pdf (Page 35)

5 Transferring Project Files

Siemens Energy & Automation, Inc. 31

In addition, the DIP Switches on the front of the

DTU3005P unit must be set to configuration mode.

The DIP Switch settings are listed below in Ta bl e

5.1.

Note: After setting the DIP Switches, cycle the

power off and on to reset the DTU3005P

to configuration mode. To reset the DIP

Switches to normal mode, cycle the

power on and off again.

When configured correctly, the status LED on the

front of the DTU3005P unit flashes green to indicate

that the unit is in configuration mode (see

Figure 5.3).

Figure 5.3 Dip Switch Settings for Normal Operation and Configuration Modes

Table 5.1 Mode Switch Setting

Mode Switch 1 Switch 2 Switch 3 Status

LED

Normal

Operation

Off Off Off On

steady

Configura-

tion

Off Off On Flashing

Green

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 119 120

Pas de commentaire

Siemens DTU3005-B Manuel de l'opérateur Page 35