Siemens EK 746 Series Instructions d'exploitation télécharger pdf (Page 53)

Connecting up

6.8 Inserting / removing the C-PLUG

SCALANCE W786 outdoor access point

Operating Instructions, 06/2013, A5E02280428-08

6.8

Inserting / removing the C-PLUG

WARNING

Danger from line voltage

Once you have removed the housing cover, there is the danger from line voltage in the

area of the connecting terminals on the power supply adapter.

Only authorized personnel is permitted to open the device and carry out any work on the

open device (e.g. connection and disconnection of lines, operating the reset button,

replacing the C-PLUG).

NOTICE

A C-PLUG may only be inserted or removed when the device is turned off.

Inserting the C-PLUG

Figure 6-9 Location of the C-PLUG with the housing cover removed

Follow the steps below to insert a C-PLUG in the device:

1. Turn off the power to the device.

2. Remove the housing cover, see section "Removing/fitting the housing cover".

3. Remove the C-PLUG from the slot. The housing of the C-PLUG has a protruding ridge on

the long side. The C-PLUG can only be inserted when this ridge is at the top right. The

slot in the SCALANCE W786 has a corresponding groove at this position. Make sure that

the C-PLUG is inserted completely into the slot.

4. Screw the housing cover back onto the device.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 89 90

Pas de commentaire

Siemens EK 746 Series Instructions d'exploitation Page 53