Siemens EK 746 Series Instructions d'exploitation télécharger pdf (Page 51)

Connecting up

6.6 Connection for Industrial Ethernet

SCALANCE W786 outdoor access point

Operating Instructions, 06/2013, A5E02280428-08

6.6

Connection for Industrial Ethernet

Device variants

With a SCALANCE W786, you have the choice of two Ethernet ports:

● RJ-45 jack

● ST duplex socket for multimode FO cables 1310 nm and a maximum cable length of 3000

Procedure for connecting an Ethernet cable

Figure 6-7 Position of the Ethernet port with the housing cover removed

Perform the following steps to connect an Ethernet cable to a

SCALANCE W786:

1. Insert the connector of the Ethernet cable in the corresponding socket of the SCALANCE

W786. If you use FO cables, make sure that the transmit and receive lines are correctly

connected. The location of the socket for RX and TX is shown in the figure above.

2. Secure the Ethernet cable with a strain relief clamp. For more detailed information on this

topic, refer to the section "Connecting the cables".

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 89 90

Pas de commentaire

Siemens EK 746 Series Instructions d'exploitation Page 51