Siemens HIPATH 8000 Manuel d'utilisateur télécharger pdf (Page 120)

Step by Step

Enhanced phone functions

120

Using autodial delay

A number is automatically dialed after a set delay start-

ing from the entry of the number’s last digit. The auto-

dial delay can be used:

• when dialing in idle mode

• when deflecting an incoming call

• Consultation

• when transferring an answered call.

The delay can be reduced by performing one of the fol-

lowing activities:

• pressing the

i key. This always works.

• lifting the handset. This only works if the phone

number was entered when the phone was idle or if

it was entered for a consultation call when the hand-

set was off hook.

• pressing the loudspeaker key. This only works if the

phone number was entered when the phone was

idle and the loudspeaker key was not lit or if the

phone number was entered for a consultation call

and the loudspeaker key was not lit.

Settings for autodial delay

You can also configure this setting via the Web interface

 page 271.

If you select Autodial delay, you must either confirm

the "Dial" option, press the loudspeaker key or wait until

the autodial delay expires to set up a call when dialing

with the handset on hook.

v Press the key shown until the "Settings" tab is active.

Confirm the option shown.

if nec. j Enter and confirm the user password.

Select and confirm the option shown.

If an emergency number is preset by your admin-

istrator, the autodial delay for this phone number

is reduced to one second.

The setting does not affect automatic emergency

number dialing.

User

Configuration

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 296 297

Pas de commentaire

Siemens HIPATH 8000 Manuel d'utilisateur Page 120