Siemens COM32 Guide de l'utilisateur télécharger pdf (Page 85)

ION Setup User Guide Using the Setup Assistant

LED Pulsing Screen

Some meters are preconfigured for LED pulsing. From the Energy Pulsing screen

in the Inputs/Outputs folder (or the Pulsing outputs folder, depending on the meter),

you can adjust LED pulse rates by modifying the Kt (pulse rate) registers. The Kt

value entered defines how much energy is accumulated before a pulse is sent.

Select the desired parameter and click Edit to set LED pulsing values.

NOTE

To configure the LED ports for a different pulsing application, you must re-link the Source input to the

output register of a different instantaneous power quantity in one of the Arithmetic modules. This is an

Advanced Configuration procedure. See “Working in Advanced Configuration Mode” on page 65.

Energy Pulsing Screen

If you want to use one of the digital outputs on your meter for energy pulsing

applications (Wh, kVAh, kVARh), configure it from the Energy Pulsing screen in the

Inputs/Outputs folder (or the Pulsing outputs folder, depending on your meter).

NOTE

If the ovld register is “Pulsing Suspended”, the energy is accumulating faster than the digital output can

pulse with the existing settings (the Calibration Pulser is in Overload State). Refer to the ION Reference,

Calibration Pulser Module, Detailed Module Operation section for details on how to configure the

Calibration Pulser Module’s settings.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 125 126

Pas de commentaire

Siemens COM32 Guide de l'utilisateur Page 85