Siemens SINUMERIK 802D sl Manuel de service télécharger pdf (Page 113)

Machining the machining step program manually

6.1 Tool change in the machining step program

Manual Machine Plus Turning

Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

113

7. If you press "Cancel", the tool change only takes place in this step, or

if you press "OK", the tool is also changed in all subsequent program steps.

Figure 6-8 Tool change in the machining step program, confirmation

8. Press "Cancel" to confirm the message.

The active tool is inserted into the step program as machining step.

Figure 6-9 Tool change in the machining step program

Note

If the tool change is to be performed without travelling to a fixed point, travel to a safe

machine position beforehand and save this point as work step in the step program.

;

$ERUW

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 129 130

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de service Page 113