Siemens SPCK620 Guide de l'utilisateur Page 21

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 43
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 20
Multi area view
6
Resetting a fault
21
Siemens AB
A6V10271018
Security Products
26.09.2011
There are 2 alarm symbols possible:
!
!
Alarm can not be restored. Alarm condition still present (e.g. the zone which
caused the alarm is still open). Please contact your installer if symbol is still
indicated after closing according zone (e.g. window).
Alarm can be restored.
If the alarm can be restored, press the key .
The alarm is restored.
6.4 Resetting a fault
If there is any fault, this will be displayed after login.
The symbol
!
is blinking.
The LED
!
is blinking.
NOTICE
In the below pictures a system wide fault (e.g. X-Bus cable fault) is indicated. Due
to this the fault symbol is displayed behind all area groups / areas. It is sufficient
to restore the fault once. In this case it does not matter which area group / area is
selected.
1. Scroll using the ▲ ▼ keys until the required area group is visible.
Vue de la page 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 42 43

Commentaires sur ces manuels

Pas de commentaire