Siemens SPCK620 Guide de l'utilisateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 43
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
Introduction
3
Viewing mode description
11
Siemens AB
A6V10271018
Security Products
26.09.2011
Amber
Flashing
Engineer is on site.
User
Green
On
Assigned area is unset.
Flashing
Assigned area is Partset A / B
Off
Assigned area is fullset
Alarm
Red
On
Alarm
Flashing
-
Off
No alarm
Alert
!
Amber
On
-
Flashing
Trouble
Off
No trouble
Mains
Green
On
System ok
Flashing
Mains fault
Off
No bus connection
NOTICE
The LED indications for information, area status, alarm and fault is deactivated in
idle state of the keypad. A valid user PIN has to be entered. It is configurable if
the power indication can be seen in idle state.
3.2 Viewing mode description
There are 2 viewing modes (automatic):
Multi area view: User has access to several areas. Displaying the areas is done
via area groups. If no area group is configured, only the general group All my
areas” is displayed.
Single area view: The user has only rights for 1 area. In the single area view,
only one area is displayed in large fonts and can be controlled directly.
NOTICE
The rights of a user can be restricted by the user settings or the settings of the
keypad the user is logging in to. Only if the user and the keypad that is being
used for logging in have the right for an area, the area is displayed. If the user has
the right for several areas but the keypad has only the right for one area, the user
will also see the single area view.
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 42 43

Commentaires sur ces manuels

Pas de commentaire