Siemens SICLOCK GPS1000 Instructions d'exploitation télécharger pdf (Page 79)

Parameter assignment

9-7

SICLOCK

TC100 Operating Instructions

9.2 Connecting time receivers

The following options are available for connecting the time receivers::

• Ethernet connection via NTP Server

• Ethernet connection via SIMATIC Verfahren

The following sections describe the parameter assignment options.

9.2.1 NTP server service

An NTP server is available at the Ethernet port. The NTP server supports the

modes Any/unicast and Multicast according to RFC2030.

Any / unicast (standard mode)

This mode is used by, e.g., PCs.

You activate the NTP server in Any/unicast mode with the parameter entry

/NTP Server/NTP Server/Operation (0.16.01)

= "On". The settings "Off" and "Only

when synchronized" are also available as options.

The setting "Only when synchronized" enables conditional operation. The server

service is only active when the device is externally synchronized.

Multicast

This mode has to be set explicitly for each subnet.

You can set Multicast mode for up to four subnets with the parameter

/NTP Server/Multicast[4]/Multicast[x]/Mode (0.16.02)

You define the Multicast IP address that will be used with the parameter entry

"Multicast address", e.g. 192.168.2.255.

Setting options for parameter entry mode:

• Off

• 10s – Standard mode, that is the coded time is time-zone independent

• 60s – Standard mode, that is the coded time is time-zone independent

• 10s with local time – for receivers without their own calendar

• 60s with local time – for receivers without their own calendar

You define the Multicast IP address that will be used with the parameter entry

"Multicast address".

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 123 124

Pas de commentaire

Siemens SICLOCK GPS1000 Instructions d'exploitation Page 79