Siemens IP-Module CFVA-IP Guide d'installation télécharger pdf (Page 85)

Setup

Siemens Building Technologies

Fire Safety & Security Products 08.2007

10.2 SISTORE MX NVS - IP camera - CKA4810/20

Abb. 12 SISTORE MX NVS – IP camera –– CKA4810/20 system overview

1 CKA4810/20

2 MX NVS server

3 Max. 32 IP cameras

Prerequisite:

The CKA driver is installed (see Section 6.2: Subsequently installing a hardware

driver).

1. Connect the CKA4810/4820 control panel (COM1A port) to the MX NVS

server (COM1/COM2).

2. Configure COM1A on the control panel as an RS232 interface. For more

information please refer to the respective instruction manual for control panel

CKA4810 / CKA4820.

3. Start the SISTORE MX NVS application software.

4. Switch to configuration mode.

5. Mark the checkbox CCTV keyboard on the System tab.

6. Click Apply.

Î The setting will be saved.

Î The interface for the control panel is enabled.

Connections

Signal MX NVS Server

SISTORE RemoteView

CKA4810 / CKA4820

9-pin SubD connector

GND 5 5

RXD 3 2

TXD 2 3

Interface configuration CKA4810 / CKA4820

z Protocol: SIMATRIX RS232 or SIEMENS IVM

z Baud rate: 9600

z Parity: none

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 95 96

Pas de commentaire

Siemens IP-Module CFVA-IP Guide d'installation Page 85