Siemens T1000 Manuel de service télécharger pdf (Page 102)

5-10 SPARC Enterprise T1000 Server Service Manual • April 2007

3. Get the dual-drive cable that was shipped with the new drive assembly.

4. Plug the drive connectors into the data/power connectors at the rear of the hard

drives.

Note – Make sure the connector is correctly oriented before plugging it into the

data/power connector on the drives. When connecting the cable to the data/power

connector on the lower drive in a dual-drive configuration, it may be easier to first

remove the upper drive to get a clear view of the data/power connector on the

lower drive.

■ If you have a single-drive assembly, plug the DRIVE 0 connector into the

data/power connector at the rear of the drive.

■ If you have a dual-drive assembly, make the following connections to the two

drives:

■ Plug the DRIVE 0 connector into the data/power connector on the lower drive.

■ Plug the DRIVE 1 connector into the data/power connector on the upper drive.

5. Slide the drive assembly into the chassis until it mates with the front of the

chassis.

FIGURE 5-8 shows a dual-drive assembly being inserted into the chassis. The process

is the same for a single-drive assembly.

FIGURE 5-8 Installing the Drive Assembly

Fasteners

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 131 132

Pas de commentaire

Siemens T1000 Manuel de service Page 102