Siemens SIMATIC IPC627C Instructions d'exploitation télécharger pdf (Page 48)

Commissioning

7.5 Notes on operation

SIMATIC IPC627C

48 Operating Instructions, 11/2010, A5E02669068-02

Booting from the slave hard disk

The system boots by default from the hard disk on SATA port 0. You can also configure the

system to boot from the disk on SATA port 2.

In order to allow booting from the second hard disk, you need to configure it as the primary

boot device. Make the following settings in your BIOS Setup:

Select Boot > Legacy > Hard Disk Drive > <Hard disk name> e.g. P0- ST3500418AS, then

press the "+" key to move it up in the boot order.

NOTICE

The drive letters for the partitions on both drives are assigned by the operating system

used. You can change these in the Control Panel as required.

7.5.3 RAID1 system (optional)

This is a RAID1 system configuration (mirroring with two hard disks). This configuration

enhances system availability as the system is able to continue operation if a hard drive fails,

or if there is a cable problem at a channel.

The two hard disks are configured as follows in the factory state of the device:

RAID1 system

Partition C: System, NTFS, 25 GB

Partition D: Data, NTFS, remaining capacity

Note

You can find information regarding Intel RAID controllers in the RAID documentation on the

included "Documentation and Drivers" CD in the Drivers\RAID\Intel directory.

Figure 7-1 Example

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 209 210

Pas de commentaire

Siemens SIMATIC IPC627C Instructions d'exploitation Page 48