Siemens SIMATIC IPC627C Instructions d'exploitation télécharger pdf (Page 39)

Connecting

6.2 Connecting the 100 - 240 V AC Power Supply

SIMATIC IPC627C

Operating Instructions, 11/2010, A5E02669068-02

Localized information

For countries other than the USA and Canada:

230 V supply voltage

This device is equipped with a safety-tested power cable which may only be connected to a

grounding outlet. If you choose not to use this cable, you must use a flexible cable of the

following type: Min 18 AWG conductor cross-section and 15-A / 250-V shockproof connector.

The cable set must be compliant with the safety regulations and stipulated IDs of the country

where the system is to be installed.

For the USA and Canada:

For the United States and Canada, a CSA or UL-listed power cord must be used.

The connector must be compliant with NEMA 5-15.

120 V AC power supply

To be used is a flexible power cord approved to UL and with CSA label, and which has the

following features: Type SJT with three leads, min. 18 AWG conductor cross-section, max.

4.5 m in length and parallel ground contact connector 15 A, min. 125 V.

240 VAC power supply

Use a flexible power cord which is approved to UL and CSA, and which has the following

features: Type SJT with three conductors, min. 18 AWG conductor cross-section, max.

length 4.5 m, and tandem grounded connector 15 A, min. 250 V.

Connecting

How to connect the device to the 120 V AC / 230 V AC power supply

1 Ensure that the ON/OFF switch is in "0"

position (Off) when you plug in the power cord

in order to avoid unintentional startup of the

device.

2 Connect the IEC connector

3 Connecting the power cord to the power socket

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 209 210

Pas de commentaire

Siemens SIMATIC IPC627C Instructions d'exploitation Page 39