Siemens RUGGEDCOM RSG2200 Spécifications télécharger pdf (Page 14)

Chapter 2

Installing Device

RUGGEDCOM RSG2200

Installation Guide

8 Connecting Power

Figure 4: Panel Mounting

1. Screw 2. Panel/DIN Rail Adaptor

2. Install the supplied screws to secure the adapters to the panel.

Section 2.2

Connecting Power

The RSG2200 supports single or dual redundant AC and/or DC power supplies. The use of two power modules is

recommended to provide redundancy and load balancing.

The RSG2200 can be equipped with either a screw-type or pluggable terminal block, which provides power

to both power supplies. The screw-type terminal block is installed using Philips screws and compression

plates, allowing either bare wire connections or crimped terminal lugs. Use #6 size ring lugs for secure, reliable

connections under severe shock or vibration.

NOTE

• For maximum redundancy in a dual power supply configuration, use two independent power

sources.

• For 100-240 VAC rated equipment, an appropriately rated AC circuit breaker must be installed.

• For 125/250 VDC rated equipment, an appropriately rated DC circuit breaker must be installed.

• A circuit breaker is not required for 12, 24 or 48 VDC rated power supplies.

• It is recommended to provide a separate circuit breaker for each power supply module.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 45 46

Pas de commentaire

Siemens RUGGEDCOM RSG2200 Spécifications Page 14