Siemens OSM Instructions d'exploitation télécharger pdf (Page 78)

Firmware Update

Industrial Ethernet OSM/ESM

C79000-Z8976-C068-10

Follow the steps outlined below in Hyperterminal:

1. Set up a new connection (for example with File -> New).

2. Set the following properties for the connection as shown in the dialog below:

3. Reset the OSM/ESM. Press the Select/Set button during operation, if necessary

several times until the display mode LEDs indicate the port status (all display

mode LEDs off). Then press the Select/Set button for at least 6 seconds. The

display mode LEDs begin to flash after approximately 3 seconds, 2 seconds

later the OSM/ESM is reset. (All LEDs go on briefly and then off again).

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 97 98

Pas de commentaire

Siemens OSM Instructions d'exploitation Page 78