Siemens ET1 Series Informations techniques télécharger pdf (Page 16)

INSTALLATION

2-8

2.5.3 SYSTEM MANAGE: System level functions

Below are functional descriptions for all system administration objects in

this group. Refer to table 2-3 for all available options.

Available objects:

Load Profile: Reset system with pre-defined factory profiles.

Detailed information for each profile is listed in table

2-2.

Initial 0:PCM30 1:PCM30C 2:PCM31 3:PCM31C 4: ~ 7:

CLK SEL E1 E1 E1 E1 E1 reserved

CRC OFF OFF ON OFF ON reserved

ALARM GEN NONE NONE NONE NONE NONE reserved

E BIT NONE NONE NONE NONE NONE reserved

TX/RX

MODE

CCS CAS CAS CCS CCS reserved

Idle Ch. A~D NONE NONE NONE NONE NONE Reserved

Idle Code 0XFF 0XFF 0XFF 0XFF 0XFF Reserved

Note: 1.Load profile 0 through 3 or ‘Initial System’ will cause loss of user defined

parameters.

2.Profile 4 to 7 are left blank and reserved for future use.

Table 2-2 Load Profile list

Initial System: Reset system and restore all configurable value to

factory default. Make sure this action is necessary

because all settings will be lost after command

executed.

Font Lock: When front panel is ‘Locked’, operations on buttons

are still available for viewing statistics/settings. But

changing any parameter is prohibited. Therefore,

before making any changes, NMC 9000 must be in

‘Unlock’ state. By default, NMC 9000 front panel is

locked.

Password Edit: Change the administrator’s password. This password

is used when unlocking front panel.

Clk Source Mode: Select the timing mode between ETx and TDM bus.

If Master mode selected, ETx will provide timing

clock to entire MARS 9000 system (TDM bus). If

Slave mode selected, ETx will follow the clock from

TDM bus. Only one Master is acceptable in one

MARS 9000 platform.

Clk Source Sel: Select the timing source of ETx.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Pas de commentaire

Siemens ET1 Series Informations techniques Page 16