Siemens ET1 Series Informations techniques télécharger pdf (Page 10)

INSTALLATION

2-2

2.1 Unpacking

Keep the packing box and/or shock-absorb material after unpacking ETx

modules. You may need them for safely shipping the module in the future. Rough

handling during shipping may cause module failure upon arrival. After unpacking,

check carefully for shipping damage. Contact the shipper if you notice any

damage.

2.2 Installing ETx module

The ETx module can be installed in any one of the TRS-32M slots. After it is

installed, the MARS 9000 controller will find it and start the initialization process

automatically.

When inserting this module into TRS-32M, hold the card on two screw knobs

and keep this card vertically to the floor (refer to the illustration below). Be sure

to fit the upper and bottom edge of card right in the slide-in trail before insertion

(it may crash the card if inserted without fitting in both trails). Slide this card

smoothly into chassis along the trail until bus connectors firmly fit into chassis

back plane. Double check if the card is inserted well then tighten the upper and

bottom screws by hand (to prevent from breaking the screw, tighten by a

screwdriver is not recommended).

Turn on the power supply unit with NMC-32 installed. The SCAN LED on

faceplate should start blinking in couple seconds. If it’s not blinking, please

recheck the card is correctly fitted into slot and reinstall again if necessary. If the

NO SCAN problem can’t be resolved or you have trouble installing the card,

please contact with your local dealer for technical support.

ETx

TRS-32M

Figure 2-1 Module installation

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Pas de commentaire

Siemens ET1 Series Informations techniques Page 10