Siemens ET1 Series Informations techniques télécharger pdf (Page 11)

INSTALLATION

2-3

2.3 Configuring ETx parameters

By default, ETx was preset to operate on CCS mode (PCM31) which may be the

most common configuration for E1 connections. There are 4 factory profiles

hard-coded in the system, each of them defines one type of commonly used E1

configuration (a table is provided in PROFILE group at section 2.5.3 SYSTEM

MANAGE for selection). To successful setup E1 links on ETx module, all

necessary parameters must be clear and confirmed. If you don’t know some of

them, consult your network operator about the detail. In case the configuration

need to be changed, two administrative interfaces are supported:

l LCD front control panel of NMC 9000:

8 Full functional menu tree driven system.

8 2 x 16 character-LCD display with back light.

8 6 function buttons to switch between menu items and changing

configurations.

8 For detailed operation instructions, please read section 2.4

“Administrative interface: LCD front panel”

l Craft interface (Available soon)

8 Use a VT-100 or compatible emulator with communication parameters

set to “Asynchronous, 8 data bit, None parity bit, 1 stop bit” to launch

the craft user interface.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Pas de commentaire

Siemens ET1 Series Informations techniques Page 11