Siemens SIMATIC TI500 Spécifications télécharger pdf (Page 298)

575 I/O Module Specification & Pinouts

E-9

SIMATIC 545/555/575 System Manual

E.4 Discrete Relay Output Module

The discrete relay output module (PPX:575–4916) allows the controller to

drive AC and DC loads of various voltage and current ranges. The loads can

be sourcing or sinking. Table E-8 shows module specifications.

Table E-8 Discrete Relay Output Module Specifications

Feature Description

Optical isolation 1500 Vrms

Isolation between commons 1500 Vrms

Isolation between chassis ground and

user circuits

1500 Vrms

Outputs 16

Commons 4

Fuses

One 3 A, 250 V, normal-blow, 5 x 20 mm

fuse per output (16 fuses total).

Replace only with UL/CSA-listed fuse.

Output type Non-latching, unprotected

Type of contact Form A

Operating voltage range

4.5 to 36 VDC

20 to 265 VAC

Maximum off-state leakage current 0.0 mA

Minimum load current per point 10.0 mA

Maximum delay time through module

10 ms, on to off;

10 ms, off to on

Temporary overload

5.0 A for 1 ms

Repetition rate 6 Hz maximum

Coil voltage requirement

24 VDC ±5% (22.8–25.2 V)

+5 V current consumption 0.9 A maximum

±12 V current consumption None

batt

current consumption

(+5 V STDBY)

None

Life cycles (@ 1 Hz repetition rate)

Full rated current

@ 0.5 A

@ 0.1 A

100,000

300,000

1,000,000

Maximum total relay contact resistance:

—at 0.5 A to 2 A load currents = 400 mOhms

—at 10 mA to 0.5 A load currents, use the following equation:

max R (ohms) = ((4.5 V/load current) x 0.05) + 0.15

The relay output module may be damaged if more than one channel is

overloaded at the same time, or if the temporary overload specification is

exceeded.

1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 321 322

Commentaires sur ces manuels

Pas de commentaire

Siemens SIMATIC TI500 Spécifications Page 298

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles/contrôleurs Siemens SIMATIC TI500