Siemens SINUMERIK 802D sl Manuel de service télécharger pdf (Page 14)

Setup functions

3.3 Tool management

SINUMERIK 802D sl pro - Turning

14 Control system overview for machine tools' sales people, 03/2008

3.3 Tool management

3.3.1 Tool list

☑ Basic configuration

For managing tools, the SINUMERIK 802D sl pro provides you with an easy-to-use tool list,

which displays all relevant tool data and wear.

● In the tool list, you can create and delete tools using softkeys.

● For each tool, you can store the following data:

– Special icon for the individual tool type with direction of tool orientation (mill or drill)

– Tools are displayed in the list with a number, e.g. T1.

– Number of the compensation block for the tool cutting edge, e.g. D1

– Tool offset data in the X/Z direction.

– Radius for drilling tool and milling tools, or plate radius for turning tools

– Values for geometry and wear in a single table

– Display of the cutting position for turning tools

● Using individual password protection, you can specify the maximum permissible input

values for tool wear to avoid collisions, for example. This can be done using display

machine data MD 208, MD 209 and MD 374.

Highlight

● All tool data at a glance

● More safety in managing tool data

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de service Page 14