Siemens FUS1010 Manuel d'utilisateur télécharger pdf (Page 99)

2-59

1010NFM-3J

Section 2

Assigning Io Output Functions

The Io analog output is a self-powered, isolated 4-20mA DC signal that varies linearly in relation to a

selected data function.

CAUTION: Do not connect to a powered loop.

To assign a function for the current output:

From [Analog Out Setup], press twice to access the [Io] option list.

To move the cursor to the desired data function press

To store selection press

ENT

NOTE: For Multi-Channel meters, refer to drawing 1010MN-7 for details. For Expanded I/O

modules, refer to drawing 1010N-7-7 and Addendum 1010FMA-14 for details.

Model Number and I/O Module Installation Drawing and Page Number*

1010N 1010N-2-7 (Sheet 2 of 2)

1010N with 1010N-7 Expanded I/O Module 1010N-7-7 (Sheet 2 of 3)

1010DN 1010N-2-7 (Sheet 2 of 2)

1010DN with 1010N-7 Expanded I/O Module 1010N-7-7 (Sheet 2 of 3)

Table To Determine Proper I/O Installation Drawings

*Note: For Ultra Precsion transducers see 1010N-7-7 (sheet 3 of 3).

Io (Isolated current) 4 to 20 mA varies in proportion to an assigned data function.

Vo (DC voltage) 0 to 10 Vdc varies in proportion to an assigned data function.

Pgen (TTL logic) 0 to 5000 Hz varies in proportion to an assigned data function.

System 1010 Analog Outputs

Vfo Spanned volumetric/mass flow rate

Vfab Spanned unsigned flow magnitude

Vs Spanned liquid sonic velocity

Valc Receive signal amplitude

Vaer Relative degree of liquid aeration/cavitation

Vsg Spaned specific gravity

Viscosity System liquid viscosity

T1 Current liquid temperature

Iin1, Iin2 Represents a re-transmit of the analog input signals (e.g.,

Pressure and Temp inputs can be transmitted on the 4/20

mA output.)

Iin3, Iin4 Same as Iin1 and Iin2 above but only available for opera-

tion in Multi-Beam and Arithmetic modes.

Analog Out Setup Data Categories

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 231 232

Pas de commentaire

Siemens FUS1010 Manuel d'utilisateur Page 99