Siemens EF 83H Series Manuel d'utilisateur Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 187
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
Installing the Module
2-2
SIMATIC 505 PROFIBUS-FMS CP User Manual
2.1 Overview of Installation
Follow
the flow of tasks shown in Figure 2-1
when
installing the FMS CP
module.
Turn
of
f power to the base.
Cable your programming device to the FMS CP module using the RS-232 port.
Power up the base. Check the status of the LEDs.
Check the baud rate setting of the jumper on header E1.
Cable the FMS CP module to the PROFIBUS network using the
PROFIBUS-FMS port.
Configure the I/O address of the FMS CP module using TISOFT
or SoftShop software.
Insert the FMS CP module into any available I/O slot in the base.
Figure 2-1 Installation
Flowchart
The following sections describe these installation tasks in detail. After these
tasks are completed, you are ready to install the COM5434 Configurator
software, as described in Section 5.1.
Flow of T
asks
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 186 187

Commentaires sur ces manuels

Pas de commentaire