Siemens CP 1515 Manuel d'utilisateur télécharger pdf (Page 209)

$GY DQFHG3DUDPHWHUV

Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager

C79000-G8976-C171-01 209

 ,3DGGUHVV

Each Access Point RLM needs an unique IP address. Use either:

• DHCP, to obtain an IP address automatically, or

• manually enter an IP address

127(

All Access Point RLMs must have a unique IP address value to allow

you to address each Radio Link Module specifically. Duplicate IP

address values may cause unexpected behavior of the network and/

or negative impact on network performance.

  0DQXDOO\DVVLJQDQ,3DGGUHVV

In case of manually assigning an IP address, use the field $FFHVV3RLQW,3

$GGUHVV to enter a value from the range of IP addresses assigned to your

organization.

The IP address is primarily used to address this Access Point RLM when you

use the RLM Manager program to configure and/or monitor this device.

When your organization does not use IP addressing, you can enter a user-

defined value. For example a value of the same pattern as the factory-set IP

address 153.69.254.254, where you replace the last three digits with a

numerical value in the range of “1” to “253”.

 $XWRPDWLFDOO\ DVVLJ QDQ,3 DGGUHVV

In case when a DHCP server is available on the network, an IP address will

be automatically assigned to the Radio Link Module by the DHCP server. To

enable automatically obtaining an IP address form the DHCP server, select

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 298 299

Pas de commentaire

Siemens CP 1515 Manuel d'utilisateur Page 209