Siemens Advance Network Gateway Manuel d'utilisateur télécharger pdf (Page 50)

44 •• Data Communications Setup 2000591-001

Establishing a Connection

Once your PC is set up, as described in Configuring Your PC, you are

ready to connect to and configure the ANG_DN.

… read through this Chapter prior to performing any procedures.

The unit is a fully redundant unit with dual advance network communica-

tions boards (ANCB) and power supplies. Each half is assigned a chan-

nel designation (A or B) and an IP Address.

Each half to be configured as Channel A or Channel B

ANCB

Cross Link Cable

PC COM

Ports

1. Connect a standard 9-pin COM cable from the designated PC COM

port (Figure 2-7) to RS232 Configuration Port located on etiher

ANCB.

2. Turn on the AC power to the ANG.

The user interface program is password protected. This insures the data

integrity of all configuration data and limits unwanted access of the

User’s network. To access any of the programs you must logon with the

correct password.

Description

Getting Started

Dual System

Before You Begin

Password Protection

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 94 95

Pas de commentaire

Siemens Advance Network Gateway Manuel d'utilisateur Page 50