Siemens TE503521DE Manuel d'utilisateur Page 45

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 94
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 44
41
en
Problem Cause Solution
The water lter does not
stay in position in the
water tank (16)�
The water lter is not
mounted correctly�
Firmly press the water lter
straight down into the tank
connection�
Display shows
Check water tank
Water tank has been
incorrectly inserted or the
new water lter has not
been rinsed according to
instructions�
Insert the water tank correctly or
rinse the water lter according to
instructions and then switch on�
Carbonated water in the
water tank�
Fill the water tank with fresh tap
water
The coffee grounds are
not compact and are too
wet�
The grinding setting is too
ne or too coarse, or not
enough ground coffee has
been used�
Adjust the grinding unit to a
coarser or ner setting, or use
2 level measuring spoons of
ground coffee�
Display shows
Clean brewing unit
Brewing unit (5) is soiled� Clean brewing unit (5)�
Too much pre-ground
coffee in the brewing unit
(5)�
Clean brewing unit (5)� Pour in
no more than 2 level measuring
spoons of ground coffee�
The brewing units
mechanism is stiff�
Remove and clean the brewing
unit, see “Maintenance and
daily cleaning”�
Coffee or milk froth quality
varies considerably
Build-up of limescale in the
appliance�
Descale the appliance as
described in the instructions�
Water dripped onto the
inner oor of the appliance
when the drip tray (8) was
removed�
Drip tray (8) removed too
early
Wait a few seconds after the
last drink was dispensed before
removing the drip tray (8)�
Display shows
Insert brewing unit
Brewing unit (5) is missing
or was not recognised�
Switch off the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance�
Restore the unit to its
original factory settings
(“Reset”).
You changed some settings
and want to discard them�
Turn off the unit with the power
on/off switch O / I (9)� Press and
hold the
e off / j (12) and the h
(11) button and turn the appliance
on with the power on/off switch
O / I (9). Conrm by pressing
the start button start (10)�
The factory settings are now
activated�
If you are unable to solve the problem, always call the hotline!
You will nd the telephone numbers at the back of these instructions.
Vue de la page 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 93 94

Commentaires sur ces manuels

Pas de commentaire