Siemens RDG160KN Manuel de service télécharger pdf (Page 12)

Commissioning notes

The room thermostats are delivered with a fixed set of applications.

Select and activate the relevant application during commissioning using one of the

following tools:

− Local DIP switch and HMI

− Synco ACS

− ETS

Set the DIP switches before snapping the thermostat to the mounting plate, if you

want to select an application via DIP switches.

All DIP switches need to be set to “OFF” ("remote configuration"), if you want to

select an application via commissioning tool.

After power is applied, the thermostat resets and all LCD segments flash, indica-

ting that the reset was correct. After the reset, which takes about 3 seconds, the

thermostat is ready for commissioning by qualified HVAC staff.

If all DIP switches are OFF, the display reads "NO APPL" to indicate that

application commissioning via a tool is required.

Each time the application is changed, the thermostat reloads the factory setting for

all control parameters, except for KNX device and zone addresses!

Connect the Synco ACS or ETS tools to the KNX bus cable at any point for

commissioning:

N Y1

X1 M

3191A03

Q1 Q2

CE+ CE-

KNX

V24

ETS

RS232

Siemens

N148 /

UP146 /

UP152

KNX

USB

ETS / ACS

Siemens

OCI700

GND

Y3 Y4

ACS and ETS require an interface:

− RS232 KNX interface (e.g. Siemens N148 / UP146 / UP152)

− OCI700 USB- KNX interface

An external KNX bus power supply is required if an RDG1...KN is connected

directly to a tool (ACS or ETS) via KNX interface.

The thermostat's control parameters can be set to ensure optimum performance of

the entire system (see basic documentation P3191).

The parameters can be adjusted using

− Local HMI

− Synco ACS

− ETS

Applications

Note

Connect tool

Note

Control parameters

12 / 21

Siemens RDG100KN, RDG160KN Room thermostats with KNX communications CE1N3191en

Building Technologies 2014-05-23

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Commentaires sur ces manuels

Pas de commentaire

Siemens RDG160KN Manuel de service Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Thermostats Siemens RDG160KN