Siemens SQM5 Instructions d'exploitation télécharger pdf (Page 20)

Technical Instructions SQM5… Reversing Actuators

Document No. 155-517P25

February 22, 2006

Page 20 Siemens Building Technologies, Inc.

Reversing Rotational

Direction, Continued

8. Firmly tighten the black potentiometer cam attachment screw while manually

holding the potentiometer position indication pointer in alignment. Check the

alignment again.

9. Re-install the white actuator-indicating dial by gently pressing it onto the

potentiometer cam attachment screw. Align scale position “0” on the actuator

position indicating dial with the dial pointer by rotating the dial in the clockwise

direction to avoid loosening the potentiometer cam attachment screw.

Shaft Installation

See Installation and Operation Instructions.

Preparation Before

Circuit Board Installation

WARNING:

Disconnect the power supply to the actuator before replacing the circuit

boards.

The black circuit board mounting

bracket, installed on the inside base of

the SQM5… actuator has four vertical,

slotted circuit board supports. Remove

the terminal section and circuit board(s)

from the mounting bracket.

The actuator motor capacitor is

attached to the lower section of the gray

plastic switch housing using snap-on

holding clips. Gently pull the capacitor

forward until it unclips and temporarily

place it on top of the gear housing. See

Figure 18.

EA0570R1

CAPACITOR

Figure 18.

CAUTION:

Do not disconnect any capacitor wiring.

AGA56.41/42/43

Circuit Board

Installation

1. Remove the AGA56.41/42/43…

circuit board from the packaging. The

circuit board is shipped as one board.

2. Separate the board at the perforation

by holding the circuit board at both

ends and gently bending the board

until it separates.

3. Move the terminal section containing

the auto/manual switch to the

opposite end of the base circuit

board.

4. From the switch housing side of the

actuator, guide the base circuit board

into the bottom of the circuit board

mounting bracket. See Figure 19.

BASE

CIRCUIT

BOARD

EA0574R1

TERMINAL

SECTION

Figure 19.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Siemens SQM5 Instructions d'exploitation Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires et composants de véhicules automobiles Siemens SQM5